News

Get a configuration proposal

Tell us your product, target BPH, bottle sizes and preform details. We reply with a layout drawing.

Request proposal → No spam. We respond by email.

ISO 9001 · CE · SGS
500+ lines · 80+ countries

Aluminum Can Depalletizer: Sweep, Layer or Bulk Discharge

Views: 4604 Author: Howie SUN Publish Time: 2022-07-18

Aluminum cans fill faster than bottles and forgive less: dissolved oxygen and seam tightness decide shelf life, and neither is visible on the line.

Aluminum Can Depalletizer at Sunswell Machinery

Project at a glance

Destination	Export project
Rated output	Set by the order
Configuration	conveyor, palletizer
Product	aluminum can filling
Supply scope	Supply, factory test, shipping, commissioning
Record	Order and delivery notes below

What was ordered?

Hydraulic car put the whole stack bottles into unstacking station (hydraulic lift table).

What was non-standard about the project?

Nursing bottle cylinder starts, cover entire stack bottles from three sides.

Station	Function in the line
Conveyor	Transfer between stations
Palletizer	End-of-line handling

The Aluminum Can Filling Machine for Beer, Carbonated Soft Drink is the reference unit for this configuration.

What does the delivery record show?

Hydraulic lifts start, hold the board rise to a certain height crib.

Folder separator cylinder starts, Spacer clip Tightly clamp the Partition.

Bottle holding cylinder in the Transfer mechanism starts, clamping the whole layer of the bottles from four sides, Moving in parallel to an outlet conveyor belt.

The specification sheet for the Aluminum Can Filling Machine for Hotfill Juice and Tea carries the utility figures quoted here.

Frequently asked questions

What does the order cover?

The order covers supply, factory test, shipping and commissioning, configured with conveyor, palletizer. The line was specified for aluminum can filling.

What capacity was specified, and what should the plant plan on?

Set by the order at the format named on the order. Rated figures exclude changeover, CIP and downstream stops, so plan production on 0.65-0.85 of that number.

What was non-standard about the project?

The non-standard items are the ones recorded in the section above. Everything else follows the standard configuration for aluminum can filling.

How is the line handed over?

Factory acceptance test before shipment, then installation and commissioning on site. Operator training is part of the handover, not an extra.

What is covered after handover?

Spare parts for the wear items, remote support, and a commissioning report that records the settings the line was left running at.

Key takeaways

Export project took delivery of a line rated Set by the order, configured for aluminum can filling.
Scope ran from factory test to commissioning: supply, factory test, shipping and commissioning.
The non-standard items are listed above rather than left to the order correspondence.

Machine and line details

Aluminum Can Depalletizer at Sunswell Machinery

About the author

Written by the Sunswell engineering team - led by Howie SUN, Founder & CEO, with 14 years in filling and blow-moulding equipment R&D and turnkey project delivery across 71+ countries.

Last reviewed: 2026-08-28 . Reviewed by Sunswell engineering team

Request a proposal →