| Filling method | Load cell net-weight, or piston dosing |
| Output range | 12,000-36,000 BPH at 0.2-2 L |
| Viscosity | Up to 10,000 cP |
| Accuracy | Plus or minus 0.5 g per bottle |
| Bottle or can | PET or glass |
| Key control | Weight per bottle, temperature, drip-free cut-off |
Oil clings. A valve that cuts off cleanly on water leaves a thread of oil on the bottle shoulder, and that thread becomes a rejected bottle and a dirty conveyor. The cut-off profile, the nozzle tip and the suck-back setting are the three things to watch at acceptance, not the fill speed.
Weigh a fixed sample at the start, middle and end of a shift, on the same scale, and record the temperature at the same time. A filler that holds plus or minus 0.5 g at a steady 25 C may drift at 18 C. Acceptance without a temperature record is an argument waiting to happen.
| Dosing method | Accuracy basis | When it fits |
|---|---|---|
| Load cell | Net weight per bottle | Density moves with temperature |
| Piston | Displacement volume | Stable density, high speed, thick product |
| Volumetric valve | Chamber volume | Low-viscosity oil at steady temperature |
| Flow meter | Measured volume | Continuous flow, limited pulp or solids |
Valve count, utility schedule and footprint sit on the Edible Oil Load Cell page.
A piston filler doses by displacement and is faster and simpler for thick products with a stable density. A load cell is better when the product density moves, when the bottle weight varies, or when the legal fill is defined by net content. For high-value oil in variable PET, weight wins.
Valve count, utility schedule and footprint sit on the Filling Machine for Viscous Product page.
Nothing, if the filler tares each bottle before dosing. That tare step is what separates net-weight filling from a flow meter. Without it, a heavy bottle delivers less product and the label claim fails.
The same question is worked through from another angle in Weighing filling machine for cooking oil for Russian customer.
Plus or minus 0.5 g per bottle on the reference specification. Real drift depends on product temperature, valve cut-off and the scale calibration interval, so the acceptance test should record all three.
Usually air entrained in the product or a fill that starts too fast. Letting the product settle in the bowl and ramping the valve opening removes most of it without changing the pump.
No. Oil is filled at the temperature that gives a clean cut-off and a stable weight. Heating is used to lower viscosity when the product is cold, not to preserve it.
With a flushing cycle sized for the oil and the pipe run. High-viscosity oil needs a warm flush and a longer drain time than water, and the changeover belongs in the production plan.
Country: Kazakhstan
Product: PET Bottled Carbonated Soft Drinks
Capacity: 12000BPH (1L)
Solution:Carbonated Drinks Production Line
Country: Maldives
Product: PET Bottled Mineralized Water
Capacity: 24,000BPH (500ml); 2 Lines
Solution:Water Production Line