| Types | Shrink wrap, wrap-around carton, carton packing, tray |
| Throughput | Matched to the filler; usually the line bottleneck |
| Key control | Film tension, seal temperature, case squareness |
| Wetted parts | PE film, corrugated board, tray board |
| Key decision | Shrink, carton or tray |
| Line position | After labelling, before palletizing |
Film tension and seal temperature. A pack that is tight on the line but loose after cooling has been sealed too cold; a pack with a torn corner has been sealed too hot or cooled too fast. Both show up as returns, not as line stops, which is why they are easy to miss at commissioning.
From the pack footprint plus the wrap allowance and the tunnel shrinkage. A film that is too narrow leaves the base exposed; too wide and the pack gets a double layer at the seam. Width is a per-format setting, like the lane guides.
| Pack format | Cost per case | What it protects |
|---|---|---|
| Shrink wrap | Lowest | Retail display, short distribution |
| Tray + shrink | Middle | Stacking and visibility |
| Wrap-around carton | Higher | Print area and long distribution |
| Regular slotted carton | Highest board use | Fragile packs and export |
Rated output, change parts and services are listed on the Wrap-round Film Shrink Wrapping page.
In cases per hour, at the same format, with margin for film changes and seal cooling. A packer rated below the filler sets the line rating, and the shortfall appears as bottles accumulating before the packer rather than as a machine fault.
The unit behind this configuration is the Carton Packing.
It reaches the pallet, the film width and the truck. A pattern that does not fit the pallet footprint wastes cube, and a pattern that does not match the retail unit costs the customer a repack. Pattern is a commercial decision as much as an engineering one.
The same question is worked through from another angle in The Role of Palletizers in Streamlined Packaging.
It follows the pack weight and the transport distance, and it is set with the film supplier. A thinner film saves cost per pack and fails earlier in a long distribution chain.
Usually insufficient wrap around the base or a seal that opened. Check the film width, the lap position and the seal temperature together, because changing one alone moves the failure elsewhere.
With different lane guides and a film width change, yes. The changeover is mechanical on a semi-automatic packer, so a plant selling both formats usually accepts a scheduled stop between runs.
Not without a change of the packing module. Shrink and wrap-around carton are different machines with different board or film paths, so a plant running both normally has two packers.
Country:Kazakhstan
Product: PET Bottled Sparkling Water, Canned Soft Drink, Canned Tea
Capacity: 25000CPH (250ml)
Solution:Three Lines,7000BPH(1.5L), 15000CPH(330ml),15000CPH(450ml)