| Types | Shrink wrap, wrap-around carton, carton packing, tray |
| Rate | Matched to the filler; usually the line bottleneck |
| Key control | Film tension, seal temperature, case squareness |
| Wetted parts | PE film, corrugated board, tray board |
| Key decision | Shrink, carton or tray |
| Line position | After labelling, before palletizing |
Shrink wrap is the cheapest per case and the fastest, and it suits retail where the pack is the display unit. A wrap-around carton gives print area and stack strength for distribution. A tray with shrink is a compromise used where the pack needs both protection and visibility.
Film tension and seal temperature. A pack that is tight on the line but loose after cooling has been sealed too cold; a pack with a torn corner has been sealed too hot or cooled too fast. Both show up as returns, not as line stops, which is why they are easy to miss at commissioning.
| Pack format | Cost per case | What it protects |
|---|---|---|
| Shrink wrap | Lowest | Retail display, short distribution |
| Tray + shrink | Middle | Stacking and visibility |
| Wrap-around carton | Higher | Print area and long distribution |
| Regular slotted carton | Highest board use | Fragile packs and export |
Rated output, change parts and services are listed on the Wrap-round Film Shrink Wrapping page.
A 4x6 pattern and a 3x4 pattern need different lane guides, different film width and often a different tunnel setting. On a semi-automatic packer the change is manual and takes tens of minutes; on an automatic packer it is a recipe, but only if the pattern was in the original specification.
Rated output, change parts and services are listed on the Carton Packing page.
In cases per hour, at the same format, with margin for film changes and seal cooling. A packer rated below the filler sets the line rating, and the shortfall appears as bottles accumulating before the packer rather than as a machine fault.
The same question is worked through from another angle in How to Choose a Shrink Wrapper for Your Water.
It reaches the pallet, the film width and the truck. A pattern that does not fit the pallet footprint wastes cube, and a pattern that does not match the retail unit costs the customer a repack. Pattern is a commercial decision as much as an engineering one.
It follows the pack weight and the transport distance, and it is set with the film supplier. A thinner film saves cost per pack and fails earlier in a long distribution chain.
Usually insufficient wrap around the base or a seal that opened. Check the film width, the lap position and the seal temperature together, because changing one alone moves the failure elsewhere.
It is rated in packs or cases per hour and must exceed the filler output in cases. The limiting factor is normally the tunnel dwell time, not the wrapping speed.
Too much heat, too little tension, or a film that is too thin for the pack weight. A pack that sags after cooling was sealed outside its window.
The pattern that fits the pallet footprint and the retail unit. It is decided with the palletizer and the film width at the same time, because changing it later changes three machines.
Country:Kazakhstan
Product: PET Bottled Sparkling Water, Canned Soft Drink, Canned Tea
Capacity: 25000CPH (250ml)
Solution:Three Lines,7000BPH(1.5L), 15000CPH(330ml),15000CPH(450ml)