| Filling method | Isobaric for beer and CSD, volumetric for juice and tea |
| Rated output | Up to 25,000 CPH |
| Can sizes | Standard 250, 330 and 500 ml |
| Seaming | Roller seamer integrated with the filler |
| Options | Hot fill for juice and tea, nitrogen dosing |
| Key control | Fill level, seam tightness, dissolved oxygen |
A can line is counted in cans per hour because the container is the unit the seamer closes. CPH and BPH cannot be converted without the fill volume, and the downstream packer is sized in cases per hour. Comparing a 24,000 CPH can line with a 24,000 BPH bottle line compares two different plants.
Dissolved oxygen enters at three points: deaeration of the product, the filler bowl atmosphere, and the gap between fill and seam. Nitrogen dosing and a steam or CO2 tunnel at the seamer reduce the last one. For beer and juice, the dissolved oxygen in the finished can is the number to test, not the setting on the doser.
Let's explore how attention to pressure calibration, nitrogen dosing, and temperature control can elevate your product to new levels of excellence.
| Product | Filling principle | Critical measurement |
|---|---|---|
| Beer | Isobaric, cold | Dissolved oxygen and seam tightness |
| CSD and soda | Isobaric, cold | CO2 retention and fill height |
| Juice and tea | Volumetric or hot fill | Fill temperature and seam integrity |
| Energy drinks | Isobaric or volumetric | Dissolved oxygen and closure |
For the same duty in another bottle format, the Aluminum Can Filling Machine for Beer, Carbonated Soft Drink is specified separately.
Beer and CSD run isobaric, cold, under counter-pressure. Juice and tea often run hot fill or a volumetric fill with a downstream pasteuriser. The can is the same format; the filler, the valve set and the temperature control are not, so one can line rarely covers both without a second specification.
Whether you are filling juice or CSD, precise temperature control helps retain flavor profiles, prevents microbial growth, and upholds the overall quality of the product.
Valve count, utility schedule and footprint sit on the Aluminum Can Filling Machine for Hotfill Juice and Tea page.
A heated product path, a fill temperature control loop and a cooling tunnel after seaming. The can itself tolerates the heat; the lining and the product do not always. The temperature window belongs to the product specification.
Striking the right balance in temperature control is key to delivering a consistent and exceptional beverage experience.
The same question is worked through from another angle in How to Maintain Aluminum Can Fillers for Optimal Performance.
Yes, with change parts for the filler, the seamer and the conveyor. Changeover time is the real cost. Two formats on one line normally means 40-90 minutes per switch and a lower production factor.
It is the oxygen left in the product after filling. It drives oxidation, off-flavour and haze. Beer and juice have tight limits, and the measurement belongs in the acceptance protocol, taken from the finished can.
Usually conveyor pressure or a jam at a transfer, not the can quality. Air conveyor pressure, guide rail gaps and accumulation length are the three settings to check first.
With change parts for the filler, the seamer and the conveyor, yes. The changeover is longer than a label change and is normally scheduled between campaigns.
Country: Syria
Product: Aluminum Canned Carbonated Soft Drinks
Capacity: 24000CPH (250ml)
Solution:Carbonated Drinks Production Line
Country:Kazakhstan
Product: PET Bottled Sparkling Water, Canned Soft Drink, Canned Tea
Capacity: 25000CPH (250ml)
Solution:Three Lines,7000BPH(1.5L), 15000CPH(330ml),15000CPH(450ml)